Hand Pressure Sprayer
1. Sprayer components should be properly installed. Check the connection is leaking, try to use clean water when first installed and then spray equipment Pharmacy.
2. When the first official use of additional agents, add water, liquid's surface can not exceed the safe water mark. Spraying before pulling the rocker more than 10 times, so barrel rise in atmospheric pressure to work pressure. Pulled the rocker could not be too hard to avoid an explosion chamber.
3. The initial liquid loading, due to air chamber and the spray bar contains water, the spray initial 2 to 3 minutes, the lower the concentration of exhaust liquid, it should be noted that up spray, so as not to affect the pest control effect .
4. The work is completed promptly poured barrel residual liquid, and washed with water emptied at the same time, check whether the water indoor air, if water, release water to remove the water connector.
5. If the sprayer does not use the short term, the main components should be clean, dry bottles and placed in a cool dry place. If the long-term need, they have to grease the various metal parts to prevent rust.
Save Hand Pressure Sprayer
1. Sprayer after the closure would be the first to liquid barrels, rubber hose, spray bar and other parts of the exterior cleaned, paying particular attention to clear the pump on the grease and liquid barrel concave bottom mud Department.
2. Because most of the pesticides on sprayers have some corrosion, so, after going out again in time with the alkaline wash, then rinse with water, especially Bordeaux mixture sprayed, the best to use alkaline soak 1 to 2 hours, because Bordeaux highly corrosive liquid.
3. To guard against rust. All parts can be demolished must be removed to wash away the cleaner. Spray bar, sprinkler irrigation within the wall to use oil to prevent rust damp.
4. To improve maintenance. Detailed examination of the various components, any screws often wear the location or place, must be coated with glycerol, were found to timely repair the damaged parts good.
5. Completion of the inspection, make good small parts wrapped in paper, placed in liquid storage cylinder, so as not to inadvertently lost. The sprayer should be hung in the dry and ventilated warehouse, not on the dark, dank corner, not to open storage.